CKD方向切换阀用途,喜开理方向切换阀材质
外部先导（K）型的先导空气排气为个别排气规格。先导空气的
给气口为??6快插接头，请勿弄错配管连接的位置。配管必须正
确，否则会导致动作不良。
• The main pressure (P) should be lower than the pilot pressure (PA).
Please note that the main pressure (P gas) can not be less than 0.2MPa.
Manual devices are unlocked and locked. In the depressed state, the lock is locked
on. Need to lock the occasion, must be pressed down. Do not lose this will turn loss
Bad manual device, and become the cause of air leakage and other causes.
外部先导（K）型的先导空气排气为个别排气规格。先导空气的
给气、排气气口都为M5螺纹气口，请注意不要搞错配管连接位
置。必须正确配管，否则会导致动作不良。
4G系列为内部先导式电磁阀。若不向P气口供给空气，即使操
作手动装置，主阀也不进行切换。
手动保护盖为标准装备。手动保护盖在关闭状态下出厂，交货
时看不见受保护的手动装置。请打开保护盖后，进行手动操作。

CKD方向切换阀用途,喜开理方向切换阀材质
External pilot (K) type pilot air exhaust for individual exhaust specifications. Pilot air
Do not mistake the piping connection. Piping must be positive
Indeed, otherwise it will lead to poor action.
4G series for the internal pilot solenoid valve.
If you do not supply air to the P port, even if the operation
For manual devices, the main valve is not switched.
·请注意主压力（P气口）不可低于0.2MPa。
手动装置为非锁定式和锁定式通用。在压下的状态下回转即锁
上。需要锁定的场合，必须压下回转。不压下就这样回转会损
坏手动装置，并成为造成空气泄漏等事故的原因。????
Manual protective cover for standard equipment.
 Manual protection cover in the closed state of the factory, delivery
Can not see the protected manual device.
Please open the protective cover and perform manual operation.
External pilot (K) type pilot air exhaust for individual exhaust specifications. Pilot air
To the gas, the exhaust port is M5 threaded port,
 please be careful not to make the wrong pipe connection bit
Set. Must be properly piped, otherwise it will lead to poor action.
Also, be aware that the mechanism for closing the protective cover after manual unlocking.
3-way valve 2 built-in type, through the main (P gas) supply pressure to the valve body action.