7011-C, 7011-S, 40-channel Multiplexer Cards
7111-S Quad 1×10 Multiplexer Configuration
The Model 7011 40-channel multiplexer has four independent banks of 1×10
switching. Each channel is 2-pole. These four banks can be combined for a
wide variety of switching configurations—for example, dual 1×20, or 1×10 and
1×30, or one large 1×40. The 7001 mainframe can automatically configure
the 7011 to switch 4-pole signals by combining channel pairs. This gives you a
dual 1×10 4-pole multiplexer or a single 1×20 4-pole multiplexer.
Each of the four multiplexer outputs on this card connects to the 7001/7002
mainframes analog backplane through removable jumpers for even greater flexibility. Two mainframes
7011 cards can be used to make a single 1×80 multiplexer with all intercard
connections through the backplane. The 7011 multiplexer outputs can also be
connected to the rows of the 7012 via the backplane for row expansion.
switch The Model 7111-S is a form C version of the 7011-S. The 7111-S is a low-voltage, switch
quad 1×10, single-pole form C multiplexer card. The 7111-S assembly consists
of a screw terminal connector card and a relay card. External test circuits are
7002 wired directly to the screw terminals of the connector card. 7002
• Quad 1×10 multiplexer for These cards automatically configure the 7001 or 7002 mainframe. Two conn ec
and 2-, 4-, or 8-pole operation tion options are available, screw terminal for maximum flexib ility or a single and
96-pin quick disconnect connector.
7001 • Connects to 7001/7002 7001
backplane for easy
expandability MULTIPLEX CONFIGURATION: Four independent 1×10 2-pole multiplex banks or two independent 1×10 4-pole multiplex banks.
with • 500nV, 100pA offsets Adjacent banks can be connected together. Jumpers can be removed to isolate any bank from the backplane. with
Us e CONTACT CONFIGURATION: 2-pole Form A (Hi, Lo) (1-pole form C for 7111-S). Us e
CONNECTOR TYPE:
Ordering Information 7011-C: 96-pin male DIN connector.
7011-C Quad 1×10 Multiplexer 7011-S and 7111-S: Screw terminal, #16AWG maximum wire size, with 0.092 inch O.D. 28 conductors per card maximum.
#22AWG typical wire size with 0.062 inch O.D. 88 conductors per card maximum.
with 96-pin MAXIMUM SIGNAL LEVEL:
Mass Terminated DC Signals: 110V DC between any two pins, 1A switched. 30VA (resistive load).
Connector Board AC Signals: 125V rms and 175V AC peak, between any two pins, 1A switched, 60VA (resistive load).
7011-S Quad 1×10 Multiplexer COMMON MODE VOLTAGE: 175V peak, any pin to chassis.
with Screw Terminal CONTACT LIFE: Cold Switching: 108 closures. At Maximum Signal Levels: 105 closures.
Connector Board CHANNEL RESISTANCE (per conductor): <1W.
CONTACT POTENTIAL: 7011-C: <1µV per channel contact pair 7011-S, 7111-S: <2µV per contact pair
7111-S Quad 1×10 Form <3µV typical per single contact. <5µV typical per single contact.
C Multiplexer with OFFSET CURRENT: <100pA.
Screw Terminal ACTUATION TIME: 3ms.
Connector Board ISOLATION: HI 7011-C
Bank: >109W, <25pF. Channel 1
Channel to Channel: >109W, <50pF. LO
Accessories Available Bank A Channels 2-9 J
Differential: Configured as 1×10: HI HI HI
For 7011-C: >109W, <100pF. Configured as 1×40: Channel 10 Output J Backplane
7011-KIT-R 96-pin Female Connector Kit >109W, <200pF. LO LO
7011-MTC-1 96-pin Mass Terminated Cable, Female to Common Mode: Configured as 1×10: LO
Female, 1m >109W, <200pF. Configured as 1×40:
SWITCHING AND CONTROL 7011-MTC-2 96-pin Mass Terminated Cable, Female to >109W, <600pF. J J
Female, 2m CROSSTALK (1MHz, 50W Load): Bank: Banks B – C
For 7011-S and 7111-S: <–40dB. Channel: <–40dB.
7011-ST Extra Screw Terminal Connection Board INSERTION LOSS (50W Source, 50W J J
Load): <0.1dB below 1MHz, <3dB
Services Available below 2MHz.
RELAY DRIVE CURRENT (per relay): HI
7011-C-3Y-EW 1-year factory warranty extended to 3 years 7011-C, -S: 16mA Channel 1
from date of shipment 7111-S: 28mA LO
7011-S-3Y-EW 1-year factory warranty extended to 3 years Bank D Channels 2-9 J
from date of shipment HI HI HI
7111-S-3Y-EW 1-year factory warranty extended to 3 years Channel 10 Output J Backplane
from date of shipment LO LO LO
1. 888 .KEITHLEY (U.S. only)
A Greater Measure of Confidence
Mouser Electronics
Authorized Distributor
Click to View Pricing, Inventory, Delivery & Lifecycle Information:
Keithley Instruments, Inc.:
7011-S 7111-S 7011-C 7011-R
版权与免责声明：凡本网注明“来源：兴旺宝网”的所有作品，均为浙江兴旺宝明通网络有限公司-兴旺宝网合法拥有版权或有权使用的作品，未经本网授权不得转载、摘编或利用其它方式使用上述作品。已经本网授权使用作品的，应在授权范围内使用，并注明“来源：兴旺宝网”。违反上述声明者，本网将追究其相关法律责任。 本网转载并注明自其它来源（非兴旺宝网）的作品，目的在于传递更多信息，并不代表本网赞同其观点或和对其真实性负责，不承担此类作品侵权行为的直接责任及连带责任。其他媒体、网站或个人从本网转载时，必须保留本网注明的作品第一来源，并自负版权等法律责任。 如涉及作品内容、版权等问题，请在作品发表之日起一周内与本网联系，否则视为放弃相关权利。
展开全部