GDL轻型立式多级泵

工作条件

★     冷热清洁的，非易燃易爆并不含有固体颗粒或纤维的液体；

★     液体温度：常温型-15℃至+70℃，热水型+70℃至+120℃；

★     环境温度：zui高+40℃；

★     zui小入口压力：根据NPSH曲线+zui小安全扬程量0.5米水头。

Working conditions

★     Hotcold clean, non-flammable, non-explosive liquid without solid grainfiber

★     Liquid temperature: ambient temperature-15℃~+70℃, hotwater+70℃~+120℃;

★     Highest environmental temperature: +40℃

★     Min. inlet pressure: according to NPSH curve + min. safe delivery head0.5m water head.

管路联接

Pipe coupling

典型应用                                    性能曲线  Performance curve

★     市政供水及增压

★     工业循环系统及加工系统

★     锅炉给水及冷凝液系统

★     环保水处理，渗透分析系统

★     农业灌溉及脱水

★     工业厂房清洗及各种清洗工作

★     （其他）许多专门用途

Typical application

★     Urban water supplypressure boosting

★     Industrial circulating systemprocessing system

★     Water supply for boiler or condensate system

★     Environmental protection water treatmentinfil-

tration analysis system

★     Agriculture irrigationdewatering

★     Industrial building cleaningother washing work

★     （Others） many special applications

应用范围

普通型适用于液体传输，冷热清洁水，软化水的循环和增压。

不锈钢型亦适用于微碱水、脱矿物质水、蒸馏水、游泳池水及其含氯化物液体，但液体允许温度需要降低。

Scope of application

Common type is applicable for liquid conveying, circulationboosting of hotcold clean water, soft water;

Stainless steel type is also used for water with tiny content of alkali, mineral, distilled water, water for swimming poolsolution with chloride, but the allowed temperature of the liquid shall be reduced.

性能曲线及性能表说明：

1、  所有曲线都基于3×380V，50Hz，电机在恒速2900r/min的测量值。电机为可变电压电机；

2、  测量采用自由空气下20℃的水，运动粘度r=1mm2/s；公差参照ISO2584附件B标准；

3、  泵的使用参照粗曲线的性能范围，以防止过热造成危险。

Explanation to the performance curveperformance table:

1、  All the performance curves are based on the measured values of motor 3×380, 50Hz under constant speed of 2900 r/min. The motor is of changeable voltage;

2、  Measurement is done on the basis of: 20℃ water in free air, dynamic viscosity r=1mm2/sec.; tolerance refers to attachment B of ISO2584

3、  The operation of pump shall refer to the scope of performance of the black curve to prevent danger due to overheating.

-2-

工作条件

★     冷热清洁的，非易燃易爆并不含有固体颗粒或纤维的液体；

★     液体温度：常温型-15℃至+70℃，热水型+70℃至+120℃；

★     环境温度：zui高+40℃；

★     zui小入口压力：根据NPSH曲线+zui小安全扬程量0.5米水头。

Working conditions

★     Hotcold clean, non-flammable, non-explosive liquid without solid grainfiber

★     Liquid temperature: ambient temperature-15℃~+70℃, hotwater+70℃~+120℃;

★     Highest environmental temperature: +40℃

★     Min. inlet pressure: according to NPSH curve + min. safe delivery head0.5m water head.

管路联接

Pipe coupling

尺典型应用                                      性能曲线  Performance curve

★     市政供水及增压

★     工业循环系统及加工系统

★     锅炉给水及冷凝液系统

★     环保水处理，渗透分析系统

★     农业灌溉及脱水

★     工业厨房清洗及各种清洗工作

★     （其他）许多专门用途

Typical application

★     Urban water supplypressure boosting

★     Industrial circulating systemprocessing system

★     Water supply for boiler or condensate system

★     Environmental protection water treatmentinfiltration analysis system

★     Agriculture irrigationdewatering

★     Industrial building cleaningother washing work

★     （Others） many special applications

应用范围

普通型适用于液体传输，冷热清洁水，软化水的循环和增压。

不锈钢型亦适用于微碱水、脱矿物质水、蒸馏水、游泳池水及其含氯化物液体，但液体允许温度需要降低。

Scope of application

Common type is applicable for liquid conveying, circulationboosting of hotcold clean water, soft water;

Stainless steel type is also used for water with tiny content of alkali, mineral, distilled water, water for swimming poolsolution with chloride, but the allowed temperature of the liquid shall be reduced.

性能曲线及性能表说明：

4、  所有曲线都基于3×380V，50Hz，电机在恒速2900r/min的测量值。电机为可变电压电机；

5、  测量采用自由空气下20℃的水，运动粘度r=1mm2/s；公差参照ISO2584附件B标准；

6、  泵的使用参照粗曲线的性能范围，以防止过热造成危险。

Explanation to the performance curveperformance table:

4、  All the performance curves are based on the measured values of motor 3×380, 50Hz under constant speed of 2900 r/min. The motor is of changeable voltage;

5、  Measurement is done on the basis of: 20℃ water in free air, dynamic viscosity r=1mm2/sec.; tolerance refers to attachment B of ISO2584

6、  The operation of pump shall refer to the scope of performance of the black curve to prevent danger due to overheating.

-4-

工作条件

★     冷热清洁的，非易燃易爆并不含有固体颗粒或纤维的液体；

★     液体温度：常温型-15℃至+70℃，热水型+70℃至+120℃；

★     环境温度：zui高+40℃；

★     zui小入口压力：根据NPSH曲线+zui小安全扬程量0.5米水头。

Working conditions

★     Hotcold clean, non-flammable, non-explosive liquid without solid grainfiber

★     Liquid temperature: ambient temperature-15℃~+70℃, hotwater+70℃~+120℃;

★     Highest environmental temperature: +40℃

★     Min. inlet pressure: according to NPSH curve + min. safe delivery head0.5m water head.

管路联接

Pipe coupling