EMS EM5 Embedding Molds嵌入模具

Introducing the EM5 - an innovative new design based on the widely used Ø8 mm size embedding mold. The unique two part design allows for easy removal of resin blocks, as well as incorporating many other advantages over currently available embedding products.

Features

• Separate base and tube sections that clip together to form the familiar capsule shape.
• Care should be taken that each component is free of debris before attaching together, to ensure a proper seal.
• Easy removal of resin blocks achieved by simply pulling the mold apart by hand.
• The mold can produce blocks up to 20mm in length, however shorter blocks （˜14mm） allow for easier removal. No razor blades or capsule presses are required.
• The detachable cap section allows for easier access and manipulation of a specimen.
• For more accurate specimen alignment a small amount of resin can be cured or partially cured before clipping to the body and completing the resin block. When fully cured they form strong homogeneous blocks.
• Each mold can be clipped to other molds, allowing for the creation of trays of desired size. For volatile resins, another cap section can be clipped on to the top of the mold, creating an air tight seal.
• Each cavity is numbered 1 < 5, whilst the end support stands have designated areas for writing indexing numbers or comments.

EM5  - 一种基于广泛使用的Ø8mm尺寸嵌入模具的创新设计。两部分设计可以轻松去除树脂块，并且与现有的嵌入产品相比具有许多其他优点。

特征

分开的基部和管部分夹在一起形成熟悉的胶囊形状。
在连接在一起之前，应注意每个部件没有碎屑，以确保适当的密封。
只需用手将模具拉开即可轻松去除树脂块。
模具可以生产长度达20mm的块，但是较短的块（~14mm）可以更容易地移除。不需要剃须刀片或胶囊压力机。
可拆卸的帽部分允许更容易地接近和操纵样本。
为了更准确地进行样品对准，可以在夹到主体并完成树脂块之前固化或部分固化少量树脂。当*固化时，它们形成强烈的均匀块。
每个模具可以夹在其他模具上，从而可以制造出所需尺寸的托盘。对于挥发性树脂，可以将另一个盖帽部分夹在模具顶部，形成气密密封。
每个空腔的编号为1 <5，而末端支撑架具有用于编写索引编号或注释的区域。